Pan or zoom to view detector or sensor locations on the map

If you have enabled the display of detector or sensor icons in a map, but you do not see the markers in your current map view, you may need to pan across or zoom out from the map to see them.

Note: You must have purchased FH Mobile Response Premium to view detector and sensor icons and information in FH Mobile Response. For information on upgrading from FH Mobile Response Basic to Premium, contact your FH sales representative.

  1. (If you have not done so already) Display the detectors or sensors you want to work with, as described in Display or hide detector and sensor locations on a map.

  2. Do one of the following.

    • Choose Go → Tools → Detectors → List / Filters.
    • On the Incident ribbon, in the Detectors section, click List / Filter.

    At the bottom of the interface, the Detector Browser appears, displaying a list of all the detectors or sensors. Each entry displays a color-coded status, brand type, ID, porting information, and a time stamp of the reading, depending on the sensor setup.

    The selected detector or sensor reading is highlighted in the Detector Browser, and its location on the map is marked with a red push-pin icon.

  3. (Optional) Display sensor data specific to the detector or sensor selected in the Detector Browser in one of these ways.

    • Choose Go → Tools → Detectors → Detector and Sensor Info.
    • On the Incident ribbon, in the Detectors section, click Detector and Sensor Info.

    To the right of the map, the Detector Information pane appears, displaying data for all the sensors in the selected detector, or for the single selected sensor.

  4. (Optional, in the in the Detector Browser pane) Filter the list of detectors or sensors , as described in Filter detector or sensor readings.

  5. Do one or more of the following.

    ClosedView all the detector or sensor icons

    • Do one of the following.

      • On the right side of the Detector Browser pane, choose Pan & Zoom → Zoom to All.
      • At the bottom of the Detector Information pane, choose Map Commands → Pan & Zoom → Zoom to All.

      The view in the map zooms out high enough to be able to see all the detector or sensor icons.

    ClosedPan to a specific detector or sensor icon

    1. Select the detector or sensor you want to pan to in one of these ways.

      • In the Detector Browser pane, click the listing corresponding to the detector or sensor you want to select.
      • To the right of the map, in the View / Op toolbar, click the Select / Drag icon, then in the map, click the detector or sensor you want to select.

      The push-pin icon on the map moves to the location of the detector or sensor.

    2. Do one of the following.

      • On the right side of the Detector Browser pane, choose Pan & Zoom → Pan to Selected.
      • At the bottom of the pane, choose Map Commands → Pan & Zoom → Pan to Selected.

      The view in the map moves laterally as needed to center the selected detector or sensor in the map.

    ClosedZoom to a specific detector or sensor icon

    1. Select the detector or sensor you want to zoom to in one of these ways.

      • In the Detector Browser pane, click the listing corresponding to the detector or sensor you want to select.
      • To the right of the map, in the View / Op toolbar, click the Select / Drag icon, then in the map, click the detector or sensor you want to select.

      The push-pin icon on the map moves to the location of the detector or sensor.

    2. Do one of the following.

      • On the right side of the Detector Browser pane, choose Pan & Zoom → Pan to Selected.
      • At the bottom of the pane, choose Map Commands → Pan & Zoom → Pan to Selected.

      The view in the map moves laterally as needed to center the selected detector or sensor in the map, and zooms the view in or out as needed until only the icon for the selected detector or sensor appears in the map.