3.0.5.6 Release Notes
These Release Notes are for FH Inspector 3.0.5.6 for FH 7, and provide a listing of the enhancements implemented and defects resolved during this release.
Note: FH Inspector 3.0.5 requires an iPad 2 or higher, and FIREHOUSE Software 7.15 or higher.
The following issues were resolved in this release.
When you displayed or printed the PDF for a completed inspection report, the signatures were greatly enlarged and overlapped each other.
If you had assigned an inspector to an inspection in FH, then changed the inspector in FH Inspector in the iPad, the completed inspection and PDF on the iPad showed the new inspector name. However, when you synchronized the inspections back to the FH database, the inspection still displayed the original inspector name.
On rare occasions, when synchronizing FH Inspector with the FH Cloud, an error message appeared stating that the server sent bad data, and the synchronization did not complete. FH Inspector now identifies this condition and continues the synchronization without the error. You no longer need to relicense an IPad or clear data, and new logging and diagnostics options are available so that you can send any error results to FH support to quickly resolve any issues.
The background color of the FH Inspector banner at the top of the screen, where the Done and Cancel buttons appear, was not always the correct color.
When you completed an inspection and viewed the PDF file for the violation report, at the top of the screen, the Cancel button was nearly the same color as the title bar's color, and could not be easily seen.