3.0.3 Release Notes
These Release Notes are for FH Inspector 3.0.3, and provide a listing of the defects resolved during this release.
Note: FH Inspector 3.0.3 requires an iPad 2 or higher, and either FIREHOUSE Software 7.15 or higher.
The following issues were successfully resolved this release.
If a violation notice contained a photograph, unnecessary blank space appeared below the photograph in the violation notice PDF.
If you send an email to several contacts, then open the email a second time to send it to different contacts, all the contacts that the email was sent to the first time are selected as recipients for the second email. If you clear these contacts and touch Send, the email opens and you can enter the email addresses of new recipients in the To field. However, the contacts who you had just cleared also appeared in the To field, even though you had specifically cleared them.
If you added a general inspection note to a violation report, if the note was near the end of the page, it was cut off instead of moved to the next page.
When you entered a unit number in FH Inspector on the iPad, it did not match the unit number on the FH Inspector administration web site.
If you schedule a hydrant inspection in FH but do not add a start time, when you perform the hydrant inspection in FH Inspector on the iPad, the start time is not automatically recorded when you start the inspection.
If you added a new contact with a suite number or edited an existing contact's suite number, then performed a synchronization with the FH database, the suite number does not appear in FH with the rest of the contact information.
If you opened an occupancy inspection, touched the Contact tab, and updated the information for a contact, when the data was synchronized back to the FH database, a new (duplicate) contact record was created in the database instead of updating the existing contact record.